Festool 492135 Centrotec Chuck

The Festool 492135 Centrotec Chuck is a quick-release drill accessory built for faster bit changes and a more compact drilling and driving setup on compatible Festool drills. This is a chuck designed for drilling and fastening with Centrotec bits. Model Number 492135. If you already use a Festool drill with the FastFix interface, this accessory makes the tool more nimble, lighter in the hand, and quicker to switch between tasks.

What matters here is not just that it holds bits. It changes how the drill feels in use. Festool builds this chuck around the Centrotec system, which lets compatible bits extend directly into the drill spindle. In plain terms, that gives you a more direct connection between the motor and the bit. The result is better control when driving screws, more precise handling when drilling, and less bulk hanging off the front of the tool.

The quick-change setup is the real time-saver on the job. If you bounce between pre-drilling and driving fasteners, the FastFix and Centrotec combination cuts out the usual chuck loosening and tightening routine. That means fewer interruptions during cabinet installation, trim work, punch-list work, and other jobs where constant bit swaps can eat up time fast.

Festool also keeps this accessory short for a reason. The published construction length is 37 mm, and the company states it is 50% smaller and 80% lighter than a standard chuck. That shorter nose helps when you are working inside boxes, near corners, between studs, or anywhere a full-size chuck starts getting in the way. Less front-end bulk also helps reduce fatigue during repetitive drilling and fastening.

Compatibility is a big part of the story. The Festool 492135 Centrotec Chuck is made for Festool cordless drills, cordless percussion drills, drills, and percussion drills with FastFix tool reception, except the DR 20 and DRP 20. Festool also calls out compatibility with existing and previous FastFix-equipped models including T+3, C12, TDK, TDD, and CDD series drills. Accessory Centrotec bits can also be used in non-Festool standard bit holders and chucks, which makes the bit system itself more flexible across your kit.

This accessory makes the most sense for users who already own compatible Festool drilling platforms and want faster workflow, better balance, and less wasted motion. For installers, finish carpenters, cabinet crews, remodelers, and serious DIY users who value control and clean setup changes, this is one of those small add-ons that makes a drill noticeably better to use every day.

Why the Festool 492135 Centrotec Chuck is worth adding

This is the kind of accessory that looks simple on paper but makes a compatible Festool drill feel faster, slimmer, and easier to control in real work.

• Who it’s for: Festool drill users who do a lot of drilling and fastening, especially installers, trim carpenters, cabinet crews, and remodelers.
• Why it stands out: The FastFix and Centrotec setup gives you quick bit changes, a shorter front end, and a more direct feel between the drill and the bit.
• Worth knowing: This is only a smart buy if your drill has FastFix tool reception and you plan to use Centrotec bits. If not, you will not get the full benefit.

• What does this chuck fit? It fits Festool cordless drills, cordless percussion drills, drills, and percussion drills with FastFix tool reception, except DR 20 and DRP 20.
• What bits does it use? It is designed for Centrotec quick-change bits.
• Why is this chuck different from a standard chuck? Festool states it is 50% smaller and 80% lighter than a standard chuck, and it lets Centrotec bits extend directly into the drill spindle for better control and torque.